Product Name: roller veneer dryer
 
How it works: veneer in two steel clamping down through the preheat tube under warm temperatures to steel and veneer line; and then into the drying drum rapid drying between, so you can make dried veneer flat uniform moisture content, drying quality and drying efficiency is greatly enhanced; and have direct contact with hot rollers and veneer heat transfer, thermal efficiency, heat loss, greatly reduce the heat loss characteristics.
 
Drying system: The machine adopts the most scientific principles of drying, with a centrifugal fan directly to the hot gas within the hot air into the bellows up and down the machine, the hot air through the nozzle bellows up and down to the way high-speed hot air jet, the hot air jet to run in a single board, the next two sides, the jet stream of the pressure can break through the veneer surface of saturated water vapor layer, thus accelerating heat transfer and improve the speed and efficiency of drying. Rational arrangement of the nozzle to make veneer heat evenly, so as to effectively prevent the deformation of single board, to achieve the best drying results.
 
Transmission:
   Sliced veneer vertical from the inlet into the machine, driven by the chain up and down two rows of rollers, the relative running, weight in the last roll forward under the pressure of veneer, veneer and through the two rollers, while the upper and lower nozzle, to bake the effect of dry and ironed, so this machine dried veneer was smooth, no trace.

Control system:
   With infinitely variable, depending on your veneer thickness and water content of the feed rate adjusted to achieve the desired drying effect.

Heating System:
   To bark, wood shavings, scrap wood as fuel in the stove.
Hot air after the heating cycle to heating veneer, in addition to a small row of tide, the majority of recycling, to improve the thermal efficiency and reduce drying costs.
 
Inlet width :1.35-3 m option

Drying veneer: the thinnest 0.3 mm, thickness 5.0 mm most
 
The main parameters: